OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

Source IP address

Configure one interface IP address to include in all NTP packets. The source address of NTP packets is the interface IP address the system uses to reach the network by default.

  • Configure a source IP address for NTP packets in CONFIGURATION mode.
    ntp source 
                                           interface
                                        
    • ethernet — Enter the keyword and node/slot/port information.
    • port-channel — Enter the keyword and number.
    • vlan — Enter the keyword and VLAN number (1 to 4093).
    • loopback — Enter the keyword and number (0 to 16383).
    • mgmt — Enter the keyword and node/slot/port information (default 1/1/1).

Configure source IP address

OS10(config)# ntp source ethernet 1/1/10

View source IP configuration

OS10(config)# do show running-configuration | grep source
                                 ntp source ethernet1/1/1
                              

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\