OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

spanning-tree bpdufilter

Enables or disables BPDU filtering on an interface.

Syntax
spanning-tree bpdufilter {enable | disable}
Parameters
  • enable — Enables the BPDU filtering on an interface.
  • disable — Disables the BPDU filtering on an interface.
Default
Disabled
Command Mode
INTERFACE
Usage Information
Use the enable parameter to enable BPDU filtering.
Example
OS10(conf-if-eth1/1/4)# spanning-tree bpdufilter enable
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\