OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

spanning-tree mode

Enables an STP type (RSTP, Rapid-PVST+, or MST).

Syntax
spanning-tree mode {rstp | mst | rapid-pvst}
Parameters
  • rstp — Sets the STP mode to RSTP.
  • mst — Sets the STP mode to MST.
  • rapid-pvst — Sets the STP mode to RPVST+.
Default
RPVST+
Command Mode
CONFIGURATION
Usage Information
All STP instances are stopped in the previous STP mode, and are restarted in the new mode. You can also change to RSTP/MST mode.
Example (RSTP)
OS10(config)# spanning-tree mode rstp
                                       
                                    
Example (MST)
OS10(config)# spanning-tree mode mst
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\