OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

spanning-tree port

Sets the port type as the EdgePort.

Syntax
spanning-tree port type edge
Parameters
None
Default
Not configured
Command Mode
INTERFACE
Usage Information
When you configure an EdgePort on a device running STP, the port immediately transitions to Forwarding state. Only configured ports connected to end hosts act as EdgePorts.
Example
OS10(config)# spanning-tree port type edge
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\