OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

spanning-tree vlan mac-flush-threshold

Sets the threshold value to flush MAC addresses on specified VLAN.

Syntax
spanning-tree vlan vlan-id mac-flush-threshold threshold-value
Parameters
  • vlan-id — Enter the VLAN ID number, ranging from 1 to 4093.
  • threshold-value —Enter the threshold value for the number of flushes, ranging from 0 to 65535. The default value is 0.
Default
Not configured
Command Mode
CONFIGURATION
Usage Information
The no version of this command removes the threshold value.
Example
OS10(config)# spanning-tree vlan 100 mac-flush-threshold 255
                                       
                                    
Supported Releases
10.4.0E(R1) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\