OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

spanning-tree vlan priority (Interface)

Sets an interface priority when two bridges compete for position as the root bridge.

Syntax
spanning-tree vlan vlan-id priority value
Parameters
value — Enter a priority value in the increments of 16 (0 to 240).
Default
128
Command Mode
INTERFACE
Usage Information
Breaks the tie between the two bridges which compete for root bridge.
Example
OS10(conf-if-eth1/1/4)# spanning-tree vlan 10 priority 16
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\