OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

speed (Management)

Configures the transmission speed of the Management interface.

Syntax
speed {10 | 100 | 1000 | auto}
Parameters
Set the management port speed to:
  • 10 — 10M
  • 100 — 100M
  • 1000 — 1000M
  • auto — Set the port to auto-negotiate speed with a connected device.
Defaults
Auto
Command Mode
INTERFACE
Usage Information

The speed command is supported only on the Management and Fibre Channel interfaces. This command is not supported on Ethernet interfaces.

  • When you manually configure the management port speed, match the speed of the remote device. Dell EMC highly recommends using auto-negotiation for the management port.
  • The no version of this command resets the port speed to the default value auto.
Example
OS10(conf-if-ma-1/1/1)# speed auto
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\