OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

switch

Creates a logical switch instance or modifies an existing logical switch instance.

Syntax
switch logical-switch-name
Parameters
logical-switch-name—Enter the name of the logical switch instance that you want to create or modify, a maximum of 15 characters. OS10 supports only one instance of the logical switch.
Default
None
Command Mode
OPENFLOW CONFIGURATION
Usage Information

You must configure a controller for the logical switch instance. The logical switch instance is disabled by default. To establish a connection with the controller, enable the logical switch instance using the no shutdown command. All physical and logical interfaces in the switch are assigned to the configured logical switch.

The no form of this command removes the logical switch instance.

  • NOTE: OS10 supports only one instance of the logical switch. If you attempt to create a second logical switch instance, the following message appears:
    % Warning: Only one Switch instance is supported
Example
                                       OS10# config terminal
                                       OS10 (config)# openflow
                                       OS10 (config-openflow)# switch of-switch-1
                                       OS10 (config-openflow-switch)# no shutdown
                                       
                                    
Supported Releases
10.4.1 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\