OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

template

Creates a peer-group template to assign it to BGP neighbors.

Syntax
template template-name
Parameters
template-name — Enter a peer-group template name (up to 16 characters).
Default
Not configured
Command Mode
CONFIG-ROUTER-BGP
Usage Information
Members of a peer-group template inherit the configuration properties of the template and share the same update policy. The no version of this command removes a peer-template configuration.
  • NOTE: To configure these settings for a non default VRF instance, you must first enter the ROUTER-CONFIG-VRF sub mode using the following commands:
    1. Enter the ROUTER BGP mode using the router bgp as-number command.
    2. From the ROUTER BGP mode, enter the ROUTER BGP VRF mode using the vrf vrf-name command.
Example
OS10(conf-router-bgp-10)# template solar
                                       OS10(conf-router-bgp-template)#
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\