OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

VLAN scale profile

When you scale the number of VLANs on a switch, use the VLAN scale profile so that less memory is consumed. Enable the scale profile before you configure VLANs on the switch. The scale profile globally applies L2 mode on all VLANs you create and disables L3 transmission. To enable L3 routing traffic on a VLAN, use the mode L3 command.

  1. Configure the L2 VLAN scale profile in CONFIGURATION mode.
    scale-profile vlan
  2. (Optional) Enable L3 routing on a VLAN in INTERFACE VLAN mode.
    mode L3

After you upgrade OS10 from an earlier version with configured VLANs, if you configure the VLAN scale profile and enable L3 routing on VLANs, save the configuration and reload the switch to apply the scale profile settings.

Apply VLAN scale profile
OS10(config)# scale-profile vlan
                                 OS10(config)# interface vlan 10
                                 OS10(conf-if-vl-10)# mode L3
                              

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\