OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

vlt-mac

Configures a MAC address for all peer switches in a VLT domain.

Syntax
vlt-mac mac-address
Parameters
mac-address — Enter a MAC address for the topology in nn:nn:nn:nn:nn:nn format.
Default
Not configured
Command Mode
VLT-DOMAIN
Usage Information
Use this command to minimize the time required to synchronize the default MAC address of the VLT domain on both peer devices when one peer switch reboots. If you do not configure a VLT MAC address, the MAC address of the primary peer is used as the VLT MAC address across all peers. This configuration must be symmetrical in all the peer switches to avoid any unpredictable behavior. For example, unit down or VLTi reset. The no version of this command disables the VLT MAC address configuration.
  • NOTE: Configure the VLT MAC address as symmetrical in all the VLT peer switches to avoid any unpredictable behavior when any unit is down or when VLTi is reset.
Example
OS10(conf-vlt-1)# vlt-mac 00:00:00:00:00:02
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\