OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

ztd cancel

Stops ZTD while in progress. After you cancel ZTD, you can enter CLI commands to configure the switch.

Syntax
ztd cancel
Parameters
None
Default
ZTD is enabled.
Command Mode
EXEC
Usage Information
When ZTD is enabled, the command-line interface is locked. You cannot enter OS10 configuration commands. Use the ztd cancel command to cancel the ZTD process and return to CLI configuration mode. You can enter ztd cancel only when ZTD is in a waiting state; that is, before it receives an answer from the DHCP server. Otherwise, the command returns an error message.
Example
OS10# ztd cancel
Supported Releases
10.4.1.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\