OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

aaa re-authenticate enable

Requires user re-authentication after a change in the authentication method or server.

Syntax
aaa re-authenticate enable
Parameters
None
Default
Disabled
Command Mode
EXEC
Usage Information
  • After you enable user re-authentication and change the authentication method or server, users are logged out of the switch and are prompted to log in again to re-authenticate. User re-authentication is triggered by:
    • Adding or removing a RADIUS server as a configured server host ( radius-server host command)
    • Adding or removing an authentication method ( aaa authentication [local | radius] command)
  • The no version of the command disables user re-authentication.
Example
OS10(config)# aaa re-authenticate enable
Supported Releases
10.4.0E(R1) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\