OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

activate

Enables the neighbor or peer group to be the current address-family identifier (AFI).

Syntax
activate
Parameters
None
Default
Not configured
Command Mode
ROUTER-BGP-NEIGHBOR-AF
Usage Information
This command is used for exchanging IPv4 or IPv6 address family information with IPv4 or IPv6 neighbor. IPv4 unicast Address family is enabled by default. To activate IPv6 address family for IPv6 neighbor, use the activate command. To de-activate IPv4 address family for IPv6 neighbor, use the no activate command.
Example
OS10(conf-router-neighbor)# address-family ipv4 unicast
                                       OS10(conf-router-bgp-neighbor-af)# activate
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\