OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

add-path

Allows the system to advertise multiple paths for the same destination without replacing previous paths with new ones.

Syntax
add-path {both path count | receive | send path count}
Parameters
  • both path count — Enter the number of paths to advertise to the peer, from 2 to 64.
  • receive — Receive multiple paths from the peer.
  • send path count — Enter the number of multiple paths to send multiple to the peer, from 2 to 64.
Default
Not configured
Command Mode
ROUTER-BGP-NEIGHBOR-AF
Usage Information
Advertising multiple paths to peers for the same address prefix without replacing the existing path with a new one reduces convergence times. The no version of this command disables the multiple path advertisements for the same destination.
Example (IPv4)
OS10(conf-router-bgp-af)# add-path both 64
                                       
                                    
Example (IPv6)
OS10(conf-router-bgpv6-af)# add-path both 64
                                       
                                    
Example (Receive)
OS10(conf-router-bgpv6-af)# add-path receive
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\