OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

Additional paths

The add-path command is disabled by default.

  1. Assign an AS number in CONFIGURATION mode.
    router bgp 
                                           as-number
                                        
  2. Enter a neighbor and IP address (A.B.C.D) in ROUTER-BGP mode.
    neighbor 
                                           ip-address
                                        
  3. Enter Address Family mode in ROUTER-NEIGHBOR mode.
    address-family {[ipv4 | ipv6] [unicast])
  4. Allow the specified neighbor to send or receive multiple path advertisements in ROUTER-BGP mode. The count parameter controls the number of paths that are advertised — not the number of paths received.
    add-path [both | received | send] 
                                           count
                                        

Enable additional paths

OS10(config)# router bgp 102
                                 OS10(conf-router-bgp-102)# neighbor 32.1.1.2
                                 OS10(conf-router-neighbor)# address-family ipv4 unicast 
                                 OS10(conf-router-bgp-neighbor-af)# add-path both 3 
                              

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\