OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

address-family

Enters global address family configuration mode for the IP address family.

Syntax
address-family {[ipv4 | ipv6] unicast}
Parameters
  • ipv4 unicast — Enter an IPv4 unicast address family.
  • ipv6 unicast — Enter an IPv6 unicast address family.
Default
None
Command Mode
ROUTER-BGP
Usage Information
This command applies to all IPv4 or IPv6 peers belonging to the template or neighbors only. The no version of this command removes the subsequent address-family configuration.
Example (IPv4 Unicast)
OS10(config)# router bgp 3
                                       OS10(conf-router-bgp-3)# address-family ipv4 unicast
                                       OS10(conf-router-bgpv4-af)#
                                    
Example (IPv6 Unicast)
OS10(config)# router bgp 4
                                       OS10(conf-router-bgp-4)# address-family ipv6 unicast
                                       OS10(conf-router-bgpv6-af)#
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\