OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

advertise-interval

Sets the time interval between VRRP advertisements.

Syntax
advertise-interval [ seconds | centisecs centisecs]
Parameters
  • seconds — Set the advertise interval in seconds (1 to 255).
  • centisecs centisecs — (Optional) Enter a value in multiples of 25 (25 to 4075).
Default
1 second or 100 centisecs
Command Mode
INTERFACE-VRRP
Usage Information
Dell EMC recommends keeping the default setting for this command. If you do change the time interval between VRRP advertisements on one router, change it on all routers. The no version of this command sets the VRRP advertisements timer interval back to its default value (1 second or 100 centisecs).
Example
OS10(conf-eth1/1/6-vrid-250)# advertise-interval 120 centisecs 100
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\