OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

area default-cost

Sets the metric for the summary default route generated by the ABR and sends it to the stub area. Use the area default-cost command on the border routers at the edge of a stub area.

Syntax
area area-id default-cost cost
Parameters
  • area-id — Enter the OSPF area in dotted decimal format (A.B.C.D.) or enter a number (0 to 65535).
  • cost — Enter a cost for the stub area’s advertised external route metric (0 to 65535).
Default
Cost is 1
Command Mode
ROUTER-OSPF
Usage Information
The cost is also referred as reference-bandwidth or bandwidth. The no version of this command resets the value to the default.
Example
OS10(conf-router-ospf-10)# area 10.10.1.5 default-cost 10
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\