OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

area nssa

Defines an area as a NSSA.

Syntax
area area-id nssa [default-information-originate | no-redistribution | no-summary]
Parameters
  • area-id — Enter the OSPF area ID as an IP address (A.B.C.D) or number (1 to 65535).
  • no-redistribution — (Optional) Prevents the redistribute command from distributing routes into the NSSA. Use no-redistribution command only in an NSSA ABR.
  • no-summary — (Optional) Ensures that no summary LSAs are sent into the NSSA.
Default
Not configured
Command Mode
ROUTER-OSPF
Usage Information
The no version of this command deletes an NSSA.
Example
OS10(conf-router-ospf-10)# area 10.10.1.5 nssa
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\