OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

Assign Port Channel IP Address

You can assign an IP address to a port channel and use port channels in L3 routing protocols.

Configure an IP address and mask on the interface in INTERFACE mode. ip address ip-address mask [secondary]
  • ip-address mask — Specify an IP address in dotted-decimal format (A.B.C.D) and the mask in slash format (/24).

  • secondary — Specify the IP address is the interface’s backup IP address. You can configure up to eight secondary IP addresses.

Assign Port Channel IP Address

OS10(config)# interface ethernet 1/1/1
                                 OS10(conf-if-eth1/1/1)# ip address 1.1.1.1/24
                                 OS10(conf-if-eth1/1/1)#
                                 
                              

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\