OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

Assign route-map to interface

You can assign a route-map to an interface for IPv4 or IPv6 policy-based routing to an interface.

  • Assign the IPv4 or IPv6 policy-based route-map to an interface in INTERFACE mode.
    {ip | ipv6} policy route-map 
                                           map-name
                                        
Assign route-map to an IPv4 interface
OS10(config)# interface ethernet 1/1/5
                                    OS10(conf-if-eth1/1/5)# ip policy route-map map1
                                 
Assign route-map to an IPv6 interface
OS10(conf-if-eth1/1/5)# ipv6 policy route-map map2

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\