OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

Assign Router ID

You can assign a router ID for the OSPFv3 process. Configure an arbitrary value in the IP address format for each router. Each router ID must be unique. Use the fixed router ID for the active OSPFv3 router process. Changing the router ID brings down the existing OSPFv3 adjacency. The new router ID becomes effective immediately.

  • Assign the router ID for the OSPFv3 process in ROUTER-OSPFv3 mode.
    router-id 
                                           ip-address
                                        

Assign router ID

OS10(config)# router ospfv3 100
                                 OS10(config-router-ospfv3-100)# router-id 10.10.1.5 
                              

View OSPFv3 Status

OS10# show ipv6 ospf
                                 Routing Process ospfv3 100 with ID 10.10.1.5
                                 It is an Area Border Router
                                 Min LSA origination 5000 msec, Min LSA arrival 1000 msec
                                 Min LSA hold time 0 msec, Max LSA wait time 0 msec
                                 Number of area in this router is 2, normal 2 stub 0 nssa
                                 Area  (0.0.0.0)
                                 Number of interface in this area is 1
                                 SPF algorithm executed 42 times
                                 Area  (0.0.0.1)
                                 Number of interface in this area is 1
                                 SPF algorithm executed 42 times
                                 
                              

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\