OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

Assign router identifier

For managing and troubleshooting purposes, you can assign a router ID for the OSPFv2 process. Use the router’s IP address as the router ID.

  • Assign the router ID for the OSPFv2 process in ROUTER-OSPF mode
    router-id 
                                           ip-address
                                        

Assign router ID

OS10(config)# router ospf 10
                                 OS10(conf-router-ospf-10)# router-id 10.10.1.5
                              

View OSPFv2 status

OS10# show ip ospf 10
                                 Routing Process ospf 10 with ID 10.10.1.5
                                 Supports only single TOS (TOS0) routes
                                 It is an Autonomous System Boundary Router
                                 It is Flooding according to RFC 2328
                                 Convergence Level 0
                                 Min LSA origination 0 msec, Min LSA arrival 1000 msec
                                 Min LSA hold time 5000 msec, Max LSA wait time 5000 msec
                                 Number of area in this router is 1, normal 1 stub 0 nssa 0
                                 Area (0.0.0.0)
                                 Number of interface in this area is 3
                                 SPF algorithm executed 38 times
                                 Area ranges are
                              

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\