OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

Assign service-policy

Rate controlling control traffic towards CPU requires configuring control-plane type policy. To enable CoPP, you need to apply the defined policy-map to CONTROL-PLANE mode.

  1. Enter CONTROL-PLANE mode from CONFIGURATION mode.
    control-plane
  2. Define a service-policy of type input and configure a name for the service policy in CONTROL-PLANE mode.
    service-policy input 
                                           service-policy-name
                                        
Assign control-plane service-policy
OS10(config)# control-plane
                                    OS10(conf-control-plane)# service-policy input copp1
                                 
View control-plane service-policy
OS10(conf-control-plane)# do show qos control-plane
                                    Service-policy (input): copp1
                                 

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\