OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

auto-cost reference-bandwidth

Calculates default metrics for the interface based on the configured auto-cost reference bandwidth value.

Syntax
auto-cost reference-bandwidth value
Parameters
value — Enter the reference bandwidth value to calculate the OSPF interface cost in megabits per second (1 to 4294967).
Default
100000
Command Mode
ROUTER-OSPF
Usage Information
The value set by the ip ospf cost command in INTERFACE mode overrides the cost resulting from the auto-cost command. The no version of this command resets the value to the default.
Example
OS10(config)# router ospf 10
                                       OS10(conf-router-ospf-10)# auto-cost reference-bandwidth 150 
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\