OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

bgp default local-preference

Changes the default local preference value for routes exchanged between internal BGP peers.

Syntax
default local-preference number
Parameters
number — Enter a number as the metric to assign to routes as the degree of preference for those routes. When routes compare, the route with the higher degree of preference or the local preference value is most preferred, from 1 to 4294967295.
Default
100
Command Mode
ROUTER-BGP
Usage Information
All routers apply this command setting within the AS. The no version of this command removes local preference value.
Example
OS10(conf-router-bgp-1)# default local-preference 200
                                       
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\