OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

Change to transaction-based configuration

To change to transaction-based configuration mode for a session, enter the start transaction command

  1. Change to transaction-based configuration in EXEC mode.
    start transaction
  2. Enable, for example, an interface from INTERFACE mode.
    interface ethernet 1/1/1/
                                        no shutdown
                                     
  3. Save the configuration.
    do commit
    • NOTE: After you enter the do commit command, the current session switches back to the default behavior of committing all configuration changes automatically.

Save configuration changes manually

OS10# start transaction
                              OS10# configure terminal
                              OS10(config)#
                              OS10(config)# interface ethernet 1/1/1
                              OS10(config-if-eth1/1/1)# no shutdown
                              OS10(config-if-eth1/1/1)# do commit
                           

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\