OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

channel-group

Assigns and configures a physical interface to a port-channel group.

Syntax
channel-group number mode {active | on | passive}
Parameters
  • number — Enter the port-channel group number (1 to 128). The maximum number of port-channels is 128. The maximum physical port/maximum NPU is supported.
  • mode — Enter the interface port-channel mode.
  • active — Enter to enable the LACP interface. The interface is in the Active Negotiating state when the port starts negotiations with other ports by sending LACP packets.
  • on — Enter so that the interface is not part of a dynamic LAG but acts as a static LAG member.
  • passive — Enter to only enable LACP if it detects a device. The interface is in the Passive Negotiation state when the port responds to the LACP packets that it receives but does not initiate negotiation until it detects a device.
Default
Not configured
Command Mode
INTERFACE
Usage Information
When you delete the last physical interface from a port-channel, the port-channel remains. Configure these attributes on an individual member port. If you configure a member port with an incompatible attribute, OS10 suspends that port in the port-channel. The member ports in a port-channel must have the same setting for link speed capability and duplex capability. The no version of this command removes the interface from the port-channel.
Example
OS10(config)# interface ethernet 1/1/10
                                       OS10(conf-if-eth1/1/10)# channel-group 10 mode active
                                       OS10(conf-if-eth1/1/10)# exit
                                       OS10(config)# interface ethernet 1/1/11
                                       OS10(conf-if-eth1/1/11)# channel-group 10 mode active
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\