OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

channel-group

Assigns an interface to a port-channel group.

Syntax
channel-group channel-number mode {active | on | passive}
Parameters
  • channel-number — Enter a port-channel number (1 to 128).
  • mode — Sets the LACP actor mode.
  • active — Sets channeling mode to active.
  • on — Sets channeling mode to static.
  • passive — Sets channeling mode to passive.
Default
Not configured
Command Mode
INTERFACE
Usage Information
The no version of this command resets the value to the default, and unassigns the interface from the port-channel group.
Example
OS10(config)# interface ethernet 1/1/2:1 
                                       OS10(conf-if-eth1/1/2:1)# channel-group 20 mode active
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\