OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

class-map

Creates a QoS class-map which filters traffic to match packets to the corresponding policy created for your network.

Syntax
class-map [type {qos | queuing | control-plane}] [{match-any | match-all}] class-map-name
Parameters
  • type — Enter a class-map type.
  • qos — Enter a qos type class-map.
  • queuing — Enter a queueing type class-map.
  • control-plane — Enter a control-plane type class-map.
  • match-all — Determines how packets are evaluated when multiple match criteria exist. Enter the keyword to determine that all packets must meet the match criteria to be assigned to a class.
  • match-any — Determines how packets are evaluated when multiple match criteria exist. Enter the keyword to determine that packets must meet at least one of the match criteria to be assigned to a class.
  • class-map-name — Enter a class-map name (up to 32 characters).
Defaults
  • qos — class-map type
  • match-any — class-map filter
Command Mode
CLASS-MAP-QOS
Usage Information
Apply match-any or match-all class-map filters to control-plane, qos, and queuing type class-maps.
Example
OS10(config)# class-map type qos match-all c1
                                       OS10(conf-cmap-qos)# 
                                    
Command History
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\