OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

class

Creates a QoS class for a type of policy-map.

Syntax
class class—name
Parameters
class-name — Enter a name for the class-map (up to 32 characters).
Default
Not configured
Command Mode

POLICY-MAP-QUEUEING

POLICY-MAP-QOS

POLICY-MAP-NQOS

POLICY-MAP-CP

POLICY-MAP-APPLICATION

Usage Information
If you define a class-map under a policy-map, the type ( qos, queuing, or control-plane) is the same as the policy-map. You must create this map in advance. The only exception to this rule is when the policy-map type is trust, where the class type must be qos.
Example
OS10(conf-pmap-qos)# class c1
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\