OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

clear ipv6 access-list counters

Clears IPv6 access-list counters for a specific access-list.

Syntax
clear ipv6 access-list counters [ access-list-name]
Parameters
access-list-name — (Optional) Enter the name of the IPv6 access-list to clear counters. A maximum of 140 characters.
Default
Not configured
Command Mode
EXEC
Usage Information
If you do not enter an access-list name, all IP access-list counters clear. The counter counts the number of packets that match each permit or deny statement in an access list. To get a more recent count of packets matching an access list, clear the counters to start at zero. To view access-list information, use the show access-lists command.
Example
OS10# clear ipv6 access-list counters
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\