OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

clear ipv6 route

Clears routes from the IPv6 routing table.

Syntax
clear ipv6 route {* | A::B/mask}
Parameters
  • *— Clears all routes and refreshes the IPv6 routing table. Traffic flow for all the routes in the switch is affected.
  • A::B/mask — Removes the IPv6 route and refreshes the IPv6 routing table. Traffic flow in the switch is affected only for the specified route.
Default
Not configured
Command Mode
EXEC
Usage Information
This command does not remove the static routes from the routing table.
Example
OS10# clear ipv6  route *
                                       
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\