OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

clear mac address-table dynamic

Clears L2 dynamic address entries from the MAC address table.

Syntax
clear mac address-table dynamic {all | address mac_addr | vlan vlan-id | interface {ethernet node/slot/port[:subport] | port-channel number}}
Parameters
  • all — (Optional) Delete all MAC address table entries.
  • address mac_addr — (Optional) Delete a configured MAC address from the address table (nn:nn:nn:nn:nn:nn format).
  • vlan vlan-id — (Optional) Delete all entries based on the VLAN number from the address table (1 to 4093).
  • interface — (Optional) Clear the interface type:
    • ethernet node/slot/port[:subport] — Delete the Ethernet interface configuration from the address table.
    • port-channel channel-number — Delete the port-channel interface configuration from the address table (1 to 128).
Default
Not configured
Command Mode
EXEC
Usage Information
Use the all parameter to remove all dynamic entries from the address table.
Example
OS10# clear mac address-table dynamic all
Example (VLAN)
OS10# clear mac address-table dynamic vlan 20 
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\