OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

clear spanning-tree detected-protocol

Forces the MST ports to renegotiate with neighbors.

Syntax
clear spanning-tree detected-protocol [interface {ethernet node/slot/port[:subport] | port-channel number}]
Parameters
  • interface — Enter the interface type:
    • ethernet node/slot/port[:subport] — Enter the Ethernet interface information (1 to 48).
    • port-channel number — Enter the port-channel number (1 to 128).
Default
Not configured
Command Mode
EXEC
Usage Information
Use this command to force the RPVST+ port to re-negotiate with neighbors. If you use this command without parameters, the command applies to each device port.
Example
OS10# clear spanning-tree detected-protocol interface ethernet 1/1/1
Supported Release
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\