OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

clear ufd-disable

Overrides the uplink-state group configuration and brings up the downstream interfaces.

Syntax
clear ufd-disable {interface interface-type | uplink-state-group group-id}
Parameters
  • interface-type — Enter the interface type.
  • group-id — Enter the uplink state group ID, from 1 to 32.
Default
None
Command Mode
EXEC
Usage Information
This command manually brings up a disabled downstream interface that is in UFD-disabled error state. After the downstream interface is up, it is not disabled until there are changes in the upstream interfaces. This command does not have effect on downstream interfaces that are already up or interfaces that are not part of the UFD group.
Example
OS10# clear ufd-disable interface ethernet 1/1/2
                                       OS10# clear ufd-disable uplink-state-group 1
                                       
                                    
Supported Releases
10.4.0E(R3) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\