OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

client-to-client

Enables route reflection between clients in a cluster.

Syntax
client-to-client {reflection}
Parameters
reflection — Enter to enable reflection of routes allowed in a cluster.
Default
Enabled
Command Mode
ROUTER-BGP
Usage Information
Configure the route reflector to enable route reflection between all clients. You must fully mesh all clients before you disable route reflection. The no version of this command disables route reflection in a cluster.
Example
OS10(conf-router-bgp-2)# client-to-client reflection
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\