OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

clock set

Sets the system time.

Syntax
clock set time year-month-day
Parameters
time
Enter time in the format hour: minute: second , where hour is 1 to 24; minute is 1 to 60; second is 1 to 60. For example, enter 5:15 PM as 17:15:00.
year-month-day
Enter year-month-day in the format YYYY-MM-DD, where YYYY is a four-digit year, such as 2016; MM is a month from 1 to 12; DD is a day from 1 to 31.
Default
Not configured
Command Mode
EXEC
Usage Information
Use this command to reset the system time if the system clock is out of synch with the NTP time. The hardware-based real-clock time (RTC) resets to the new time. The new system clock setting is applied immediately.
Example
OS10# clock set 18:30:10 2017-01-25
Supported Releases
10.2.1E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\