OS10 Enterprise Edition User Guide Release 10.4.0E(R3)



Configures an identifier for a BGP confederation.

confederation {identifier as-num | peers as-number}
  • identifier as-num —Enter an AS number, from 0 to 65535 for 2 bytes, 1 to 4294967295 for 4 bytes, or 0.1 to 65535.65535 for dotted format.
  • peers as-number —Enter an AS number for peers in the BGP confederation, from 1 to 4294967295.
Not configured
Command Mode
Usage Information

Configure your system to accept 4-byte formats before entering a 4-byte AS number. All routers in the Confederation must be 4-byte or 2-byte identified routers. You cannot have a mix of 2-byte and 4-byte identified routers. The autonomous system number you configure in this command is visible to the EBGP neighbors. Each autonomous system is fully meshed and contains a few connections to other autonomous systems. The next-hop (MED) and local preference information is preserved throughout the confederation. The system accepts confederation EBGP peers without a LOCAL_PREF attribute. OS10 sends AS_CONFED_SET and accepts AS_CONFED_SET and AS_CONF_SEQ. The no version of this command deletes the confederation configuration.

Example (Identifier)
OS10(conf-router-bgp-2)# confederation identifier 1
Example (Peers)
OS10(conf-router-bgp-2)# confederation peers 2
Supported Releases
10.3.0E or later

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\