OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

Configure management VRF

You can add only management interfaces to the management VRF instance.

Before you assign the management interface to the management VRF instance, remove all the configured settings, including the IP address, on the management interface.

  1. Enter the ip vrf management command in the CONFIGURATION mode. Use non-transaction-based configuration mode only. Do not use transaction-based mode.
  2. Add the management interface by using the interface management command in the VRF CONFIGURATION mode.
Configure management VRF
OS10(config)# ip vrf management
                                 OS10(conf-vrf)# interface management
                              

You can enable various services in the either of the management or default VRF instances. Refer to the following table for the services supported in the management VRF instance and the default VRF instance.

Table 1. Services supported. Services supported
Application Management VRF  Default VRF Non default VRF

COPP ACL

Yes

Yes

No

DHCP client

Yes

Yes

Yes

DHCP relay

No

Yes

Yes

DHCP server

No

Yes

Yes

DNS client

Yes

Yes

Yes

FTP client

Yes

Yes

No

HTTP client

Yes

Yes

No

ICMP / Ping

Yes

Yes

No

NTP client

Yes

Yes

No

NTP server

Yes

Yes

No

OSPFV2 /OSPFV3/BGP

No

Yes

No

RADIUS server

Yes

Yes

No

SCP client

Yes

Yes

No

sFlow

No

Yes

No

SFTP

Yes

Yes

No

SNMP traps

Yes

Yes

No

SSH   server`

Yes

Yes

No

Syslog

Yes

Yes

No

Telnet server

Yes

Yes

Yes

TFTP client

Yes

Yes

No

Traceroute

Yes

Yes

Yes

VLT backup link

Yes

Yes

No

VRRP

Yes

Yes

No


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\