OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

Configure UFT modes

Available UFT modes include L2 MAC table, L3 host table, or L3 route table sizes.

  • Select a mode to initialize the maximum table size in CONFIGURATION mode.
    hardware forwarding-table mode [scaled-l2 | scaled-l3-routes | scaled-l3-hosts]
  • Disable UFT mode in CONFIGURATION mode.
    no hardware forwarding-table
Configure UFT mode
OS10(config)# hardware forwarding-table mode scaled-l3-hosts
View UFT mode information
OS10# show hardware forwarding-table mode
                                 Current Settings           Next-boot Settings
                                 Mode                   default-mode               scaled-l3-hosts
                                 L2 MAC Entries    :    163840                     98304
                                 L3 Host Entries   :    147456                     212992
                                 L3 Route Entries  :    16384                      98304
                              
View UFT information for all modes
OS10# show hardware forwarding-table mode all
                                 Mode                default     scaled-l2   scaled-l3-routes   scaled-l3-hosts
                                 L2 MAC Entries      163840      294912      32768              98304
                                 L3 Host Entries     147456      16384       16384              212992
                                 L3 Route Entries    16384       16384       131072             98304
                              

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\