OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

Configure VLT port-channel

A VLT port-channel links an attached device and VLT peer switches, also known as a virtual link trunk.

  1. Enter the port-channel ID number on the VLT peer in INTERFACE mode, from 1 to 1024.
    interface port-channel 
                                           id-number
                                        
  2. Assign the same ID to a VLT port-channel on each VLT peer — peers are seen as a single VLT LAG to downstream devices.
    vlt-port-channel 
                                           vlt-lag-id
                                        
  3. Repeat the steps on the VLT peer.

Configure VLT LAG — peer 1

OS10(config)# interface port-channel 10
                                 OS10(conf-if-po-10)# vlt-port-channel 1
                                 
                              

Configure VLT LAG — peer 2

OS10(config)# interface port-channel 20
                                 OS10(conf-if-po-20)# vlt-port-channel 1
                                 
                              

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\