OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

continue Clause

Only BGP route-maps support the continue clause. When a match is found, set clauses run and the packet is forwarded — no route-map processing occurs. If you configure the continue clause without configuring a module, the next sequential module processes.

If you configure the continue command at the end of a module, the next module processes even after a match is found. The example shows a continue clause at the end of a route-map module — if a match is found in the route-map test module 10, module 30 processes.

Route-map continue clause

OS10(config)# route-map test permit 10
                                 OS10(conf-route-map)# continue 30
                              

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\