OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

Create port-channel

You can create up to 128 port-channels, with up to 16 port members per group. Configure a port-channel similarly to a physical interface — you can enable or configure protocols, or assign access control lists (ACLs) to a port channel. After you enable the port-channel, you can place it in L2 or L3 mode.

To place the port-channel in L2 mode or configure an IP address to place the port-channel in L3 mode, use the switchport command.

  1. Create a port-channel in CONFIGURATION mode.
    interface port-channel 
                                           id-number
                                        
  2. Ensure that the port-channel is active in PORT-CHANNEL mode.
    no shutdown
Create port-channel
OS10(config)# interface port-channel 10
                                    OS10(conf-if-po-10)# no shutdown
                                 

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\