OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

Create virtual router

VRRP uses the VRID to identify each virtual router configured. Before using VRRP, you must configure the interface with the primary IP address and enable it.

  • Create a virtual router for the interface with the VRRP identifier in INTERFACE mode (1 to 255).
    vrrp-group 
                                           vrrp-id 
                                        
  • Delete a VRRP group in INTERFACE mode.
    no vrrp-group 
                                           vrrp-id
                                        

Configure VRRP

OS10(config)# interface ethernet 1/1/5
                                 OS10(conf-if-eth1/1/5)# vrrp-group 254
                              

Verify VRRP

OS10(conf-eth1/1/5-vrid-254)# do show running-configuration
                                 ...
                                 !
                                 interface ethernet 1/1/5 
                                 ip address 10.10.10.1/24
                                 ! 
                                 vrrp-group 254 
                                 no shutdown
                                 ...
                              

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\