OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

dcbx tlv-select

Configures the DCB TLVs advertised by a DCBX-enabled port.

Syntax
dcbx tlv-select {[ets-conf] [ets-reco] [pfc]}
Parameters
  • ets-conf — Advertise ETS configuration TLVs.
  • ets-reco — Advertise ETS recommendation TLVs.
  • pfc — Advertise PFC TLVs.
Default
DCBX advertises PFC, ETS Recommendation, and ETS Configuration TLVs.
Command Mode
INTERFACE
Usage Information
A DCBX-enabled port advertises all TLVs to DCBX peers by default. If PFC or ETS TLVs are disabled, enter the command to re-enable PFC or ETS TLV advertisements. You can enable multiple TLV options (ets-conf, ets-reco, and pfc) with the same command.
Example
OS10(conf-if-eth1/1/2)# dcbx tlv-select ets-conf pfc 
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\