OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

default-router address

Assigns a default gateway to clients based on the IP address pool.

Syntax
default-router address [ address2...address8]
Parameters
  • address — Enter an IPv4 or IPv6 address to use as the default gateway for clients on the subnet in A.B.C.D or A::B format.
  • address2...address8 — (Optional) Enter up to eight IP addresses, in order of preference.
Default
Not configured
Command Mode
DHCP-POOL
Usage Information
Configure up to eight IP addresses, in order of preference. Use the no version of this command to remove the configuration.
Example
OS10(conf-dhcp-20.1.1.1)# default-router 20.1.1.100
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\