OS10 Enterprise Edition User Guide Release 10.4.0E(R3)


destination (Port Monitoring)

Sets the destination where monitored traffic is sent to. The monitoring session can be local or RPM.

destination {interface interface-type | remote-vlan vlan-id }
interface-type — Enter the interface type for a local monitoring session.
  • ethernet node/slot/port[:subport] — Enter the Ethernet interface information as the destination.
  • port-channel id-number — Enter a port-channel number as the destination (1 to 128).
  • vlan vlan-id —Enter a VLAN ID as the destination (1 to 4093).
remote-vlan vlan-id —Enter a remote VLAN ID as the destination for RPM monitoring session (1 to 4093).
Not configured
Command Mode
Usage Information
The no version of this command resets the value to the default.
OS10(conf-mon-local-10)# destination interface port-channel 10
OS10(conf-mon-rspan-source-3)# destination remote-vlan 20
Supported Releases
10.2.0E or later

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\