OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

discovery-interface

Configures the interface to discover and connect to a VLT peer in the VLT interconnect (VLTi) link between peers.

Syntax
discovery-interface {ethernet node/slot/port[:subport]}
Parameters
ethernet — Enter the Ethernet interface information for the port on a VLT peer. You can also enter a range of interfaces separated by hyphens.
Default
None
Command Mode
VLT-DOMAIN
Usage Information
The VLT node discovery service auto-LAGs the discovery ports and creates VLTi interfaces. The no version of this command disables the discovery-interface configuration.
Example
OS10(config)# vlt-domain 1
                                       OS10(conf-vlt-1)# discovery-interface ethernet 1/1/15
                                    
Example (range)
OS10(config)# vlt-domain 2
                                       OS10(conf-vlt-2)# discovery-interface ethernet 1/1/1-1/1/12
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\